Analog Irrigation Programmer Wassertech

€30.00

(€30.00 Unidad)

Tax included

1-Unscrew and remove the waterproof cap. Carefully slide out the battery compartment. Install two new AAA alkaline batteries. Put the share back on your site.
2-Place the unit in a stable place. Loosen the ring lock collar on the top of the timer until the black collar on the faucet is loose. Attach that collar to the water intake firmly, then reattach the large clasp. Open the tap of the water inlet. (Do not use pliers or wrenches to tighten the collars.)

To buy a box add 20 units.

1. Turn the Wheel to set the watering frequency in hours and the watering time in minutes. The system will not start watering immediately, it will start after the programmed frequency time has elapsed.
2. Make a record of the date and time you programmed the system with the time and frequency of watering. You can use the On / Off function at any time without affecting the frequency setting that is programmed. Turn the Watering time wheel to, then OFF for 5 seconds and you can re-program the desired watering time.

3Close the waterproof cap after you have programmed, make sure it is firmly screwed onto the timer.
-Easy to program
-Duration of irrigation from 1mn to 2h
-Frequency of irrigation in periods of 1 hour up to a week
-Fits any standard tap (25mm)
-Voltage: DC 3V (Use high performance alkaline batteries)
-Static: Equal to or less than 18uA
-Battery life: 6 months
-Operating temperature from 5 to 60║
-Pressure: from 0.5 to 8 bars